We build custom logo electric heaters that don’t just warm things up—they become part of the machine’s own identity. These aren’t off-the-shelf parts. They’re made to fit your exact voltage, wattage, and space, so the heat lands right where you need it. Here’s the power part. These heaters pack a punch in a small footprint: high heat density, often running at 400V, up to 2500W, all in about 300mm. That means fast warm-up and steady temperature control, even in tight spots. Match the heater voltage to your electrical supply, and you cut down on wiring bulk and reduce stress on the control circuitry. The 300mm length focuses the heat into a specific zone, so you’re not wasting energy across the whole machine. Now, what makes that possible? The heart of it is a quartz tube with a halogen element, built for reliable infrared output and steady resistance over time. Quartz handles sudden temperature swings without cracking and resists oxidation, even when things get seriously hot. A protective coating keeps the tube clean and helps it stay strong through repeated on/off cycles. And the connection? We use an R7s base. It’s secure, low-resistance, and easy to wire on-site. Faster install, fewer hot spots at the terminal. Where does this shine? Think PET blowing—where you need fast, localized heat, and you want the machine to look unmistakably yours. The branded exterior carries your equipment identity, while the heating system delivers repeatable performance. Just one heads-up: that high watt density needs room to breathe. Plan your airflow and give the heater proper thermal clearance so nearby components don’t get cooked. Do that, and you get the performance you want—without the overheating headaches.