Fixing Those Annoying Cold Spots in Glass Annealing Ever pull a piece out of the kiln only to find it cracked because one weird curve or a tight neck...

Getting the Heat Just Right: Custom Spectra for Twin Tube IR Elements Most infrared lamps just blast a broad spectrum of heat. For a lot of jobs,...

Stop the Chipping: Why Preheating Your Glass Actually Works Cutting cold glass is basically a gamble. When your cutting wheel scores a sheet, it...

The Tug-of-War Between Sharp Prints and Strong Glass When you try to silk-screen and temper glass in one go, you’re basically fighting a battle...

Stop Fighting Your Furnace: Getting Heat Where It Actually Needs to Go Let’s be honest: trying to squeeze off-the-shelf heating elements into a...

Stop Swapping Lamps and Start Looking at the Heat Here is the thing about tempered glass: you can’t just buy a few new infrared lamps, look at...

Stop Fighting Bathroom Mold: The Secret Use for IR Lamps Most people think bathroom heating lamps are just there to keep you from shivering when you...

Why You Need Fast-Response IR for Online Glass Annealing In a glass production line, stopping is the enemy. You can’t just hit the brakes...

Out on the line, yield lives or dies at the edge. One hairline thermal fracture near the perimeter can kill a tempered pane that passed every earlier...

Out on the plant floor, heat isn’t just another setting. It’s the line between a pane that clears inspection and one that fails when thermal stress...

On the tempering line, the marver section is where you lock in the edge profile and set the thermal gradient before the glass hits the quench. If the...